INSTRUCTIONS

Follow these 4 simple steps to properly install your Dog Bone mount for a secure and reliable setup.

  1. Mounting the Base – You’ll need a stud finder, level, phillips screwdriver, or power tools. Use the supplied screws to locate and secure the base to a wall stud, just as you would when mounting a TV. Ensure it is level and firmly attached.
  2. Adjusting the QD Lever – The QD lever comes pre-installed. Rotate it clockwise to tighten the grip or counterclockwise to loosen it. Don't worry, if you need to switch it to the other side or turn the trigger block upside down, we got you. Watch the quick video below for a step-by-step guide on assembling the QD lever.
  3. Choose the QD Lever's orientation – Our QD Level is completely rotatable. The position can be adjusted by loosening the securing screw and tightening it to set the position.
  4. Final Check – Ensure your firearm’s safety is set to SAFE before mounting it to the Dog Bone. Make final adjustments to ensure a snug fit, verifying that the safety cannot be switched to FIRE while mounted and that the firearm cannot be easily snagged out of the mount.

For additional support, troubleshooting, or video instructions, visit youtube.com/@MidratsDefense or email us at contact@midratsdefense.com

 

Legal Disclaimer & Safety Warning
Always follow proper firearm safety protocols when installing and using the Dog Bone mount.
Ensure your firearm is completely unloaded before installation or adjustment.
Keep your finger off the trigger and follow all firearm handling best practices.
The safety must remain on SAFE while the firearm is mounted.
Regularly inspect the mount to ensure it remains secure and functions properly.
Midrats Defense is not responsible for any misuse, improper installation, or failure to follow standard firearm safety procedures. Always comply with local laws and regulations regarding firearm storage and handling.
By using this product, you assume all responsibility for its proper use and safe handling.